Yep, and with what I gather was alot of bad blood and was over 30 years ago. Some cant move on. I am a member of this club and have been for years. I have mooted re-joining NZDA many times and...
Liked On: 30-09-2018, 09:02 AM
The one in Hutt Valley is run by some grumpy old cnts. all i do is use the range for load development and sighting in. It seems like the attitude is pay the subs and piss off don't ask questions....
Liked On: 30-09-2018, 08:59 AM
Strangely enough I found North Auckland to be the opposite of how you describe it in the 90s I went along to Auckland and then North Auckland and personally found the Guys at North Auckland far more...
Liked On: 30-09-2018, 08:56 AM
I never realised that I had that affect on you Maca - but I always enjoy your company :omg: it seems they are very proactive and are trying to engage with their members - often organizing trips for...
Liked On: 30-09-2018, 08:50 AM
I've always found the nzda to be good fun on party Hunt's and good for advice but for actually getting people to take you out if you're new is hard. I've been to every meeting for a year and talk to...
Liked On: 30-09-2018, 08:49 AM
Also remember, a rifle that shoots an inch group at 100 all day long, does not necessarily shoot a 4 inch group at 400 all day long. The further out you get, the more variables come into play
Liked On: 27-09-2018, 11:07 PM
1inch /100m is my rule of thumb, 400m =4 inch group... It should be a lot better but its a starting point
Liked On: 27-09-2018, 11:07 PM
Mine also broke, now I use a shell holder instead of the collet.
Liked On: 27-09-2018, 10:57 PM
Just picked up a hornady cam lock bullet puller after years of useing a hammer one As I had over 100 rounds of unwanted ammunition to pull and save bullets etc Took less than an hour and doesn’t so...
Liked On: 27-09-2018, 10:56 PM
44-45 2208 with a 120 bt should see you right.
Liked On: 27-09-2018, 10:27 PM
That's the question right there. Is the plan made in 1993 and largely ignored since applicable to today's range and population densities, and can we redress the balance and still active the...
Liked On: 26-09-2018, 12:12 AM
Chris, you should say who you are, some on this forum may not know, it will add more credibility to the advice youve given above.
Liked On: 26-09-2018, 12:06 AM
+1 for don't over tighten the action screws. 25 -30lbs torque max. If you over tighten you will compress the plastic stock and it wont recover. If you can get hold of another tikka stock from...
Liked On: 26-09-2018, 12:03 AM
What Friwi said about the action screw torque. What have you been tightening the screws to? Just “tight” as in when the screws stop and a little bit more, or “proper tight” as is when the screws turn...
Liked On: 26-09-2018, 12:02 AM
Have you tried removing and checking the rings and bases, they can be a common cause of problems. You will know when the action is in the recoil lug correctly as the action usually snaps into...
Liked On: 26-09-2018, 12:00 AM