C H, just a small bit of tin, I have some pure tin and or a bit of solder will do it, helps fill out the mould.
Type: Posts; User: homebrew.357
C H, just a small bit of tin, I have some pure tin and or a bit of solder will do it, helps fill out the mould.
I think a card wad over the powder helps seal the bullet base and also keeps the lube from getting into your powder charge . Always looks good when I shoot at 50m and have shot better ones with pp...
O heck, #1 , Off the sticks/ no all shot off the bench, sticks was a shooting at the rams. #2, Lead alloy, pure lead, bit of linotype and tin. #3, Using 2f Swiss with small bit of compression . #4,...
Hi 40mm, if you look back up the thread you will see 4 45-70 loaded cases, it`s a 1874 Sharps falling block, great fun.
81320, The Quigley Sharps, 45-70.
Yea, you could be right, but I like one powder for all my rifle reloading and 3031 is good in 308,3030 and the Sharps , have tried A D I 2208 not to bad in the Sharps with medium loads . The main...
OK, Update on the 488gr cast bullets, tried some with 3031, 35.5gr and 40gr, at 100m not good , five shots and no holes in the target. All were going over the top and when I did get some on they were...
Pervert !, now I`ll have to hide them away form all the girl shooter at the range, specially with my pink bullet lube, would think I`m a dirty old man. "Look at that mans bullets, don`t they look...
:XD:!!,I just knew it, now I will have to explain what's the ring on the nose!!!. A bloody glitch in my nose cutter, it picked up a lump of ali and that's the result but may be ok as a bigger...
Bugged if I know, I`v got a lump of ali 8' wide x .650" thick and all my moulds come form that, I`v no idea what type of ali it is so you should be ok, just smoke the mould before casting . My...
Hi all, did my normal on lathe bullet mould making bit for a 500gr single bullet mould in ali and had a try out to see what I have got. Dropped out of the mould nicely and weight was 488grs, so not...