shooternz Thanks Rob, these molds have had a similar cure process, I have been exceedingly fortunate to count the CBK as a friend who tolerates my newbie questions, the mold has really come into its...
Type: Posts; User: Tertle
shooternz Thanks Rob, these molds have had a similar cure process, I have been exceedingly fortunate to count the CBK as a friend who tolerates my newbie questions, the mold has really come into its...
I had given that some thought, my thinking was that this doesn’t have the same controlled expansion that a jacketed projectile offers? Plus moving the center of balance back just a tad may help what...
im also wondering if i delicately remove a little metal on the pin and make a slot for the grub srew to locate and sit in that might help?
im going to run the mold today and see how it goes, i will use extremely dry thin macrocarpa to smoke the mold again, ill make sure the pin is hot too, hopefully that ought address the issue, but id...
So 6am and I fixed it, small grub screw, I’ll find a small Allan key to really get it in propper, just wondering is there a heat resistant loc tight?
But I need to fix the HP pin!
Good prep, hot mold and well smoked, NOT from a candle, I have a mix that I try to keep to and add a little solder……and a shit ton of luck ;)
175203
That’s as they fell!
They ought to be fun, but I would like to cast more of them!
175190
So, tonight was 25cal night, dug out my NOE 25 cal 4 cavity mold, it casts 3 @ 120gr, 1is a hp, and 1 @ 85gr, smoked up the cavity and the hp pin, was casting really really nicely then……pin comes out...