Search:

Only takes a couple of minutes and makes a big difference to the intensity of the beam, basically double from what we've measured with the lux meter.

Sounds bloody dodgy to me. :thumbsup:

They are easy to do but you do need to be quite careful as the connecting wires are soft gold and very small.

I must admit to being tempted with HID.

crnkin

I've stripped out a dead laptop power adapter and scavenged 4 100ohm SMD's. Could probably find a heap more. How many you looking for?

No 100r SMD's sorry Chris, though I could probably find some.

Trouble with driving the LED's too hard is that the efficiency drops very low and the runtime with it. The internal resistance of the...

There are heaps that can be hooked up to a bike, but what do you want to do with it. Replace headlights or have as a moveable spotlight?

I'm looking at a couple of these for the quad

10W 950lm...

I do them a little differently. Pop the Aluminium LED circuit board out and put the soldering iron gas torch to the back till it softens the solder underneath the LED. Then I press down on the dome...

I can't find any Rabbi's round here, think we shot too many of them.

Tattler.

Yeah, we're all holding off for the new one too. Good that they have taken on board the recommendation to make the lighter model.

I would recommend the de-doming. Ours light up the walls of a...

Has the Maxtoch been de-domed moonhunt? This will greatly increase throw and produce a warmer colour that cuts through the atmosphere better. The

Sniper is not out yet, we've advised a few...