Search:

UPDATE
Got the dies and cases back from H&F today and it looks like my old Lee case lube was causing the problem. I am now using hornady lube on a case lube tray and it is now sizing all the way...

UPDATE
Got the dies and cases back from H&F today and it looks like my old Lee case lube was causing the problem. I am now using hornady lube on a case lube tray and it is now sizing all the way...

The brass has been trimmed to length and is ok it just won’t physically go any further into due. Shop is looking at it but I suspect you’re right and it’s a largish chamber, will see what they come...

Compared to an unfired round the shoulder on the resized brass doesn’t seem to be bumped back down enough85164

UPDATE didn’t get to measure them but they are tight to chamber!! Tried a few and they are mostly really tight to close the bolt. They were not this tight to remove after they had been fired . I’m...

THANKS for all the reply’s , I’m getting the brass measured tomorrow new fired and sized so I’ll see if that tells me anything. Also I might run a fired case through a mates dies to see if it’s the...

I sat down tonight to resize my once fired Norma brass with my hornady FL die.
The cases are really tight on the last quarter of the stroke and I’m getting a ring at the bottom of the cases where...