Welcome guest, is this your first visit? Create Account now to join.
  • Login:

Welcome to the NZ Hunting and Shooting Forums.

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed.

Search Forums

Advanced Search
Darkness ZeroPak


Search:

Type: Posts; User: 223nut

Search: Search took 0.02 seconds.

  1. 12-04-2017, 11:31 PM

    Thread: Torquing stock screws

    by 223nut
    Replies
    20
    Views
    3,393

    Cos I'm too cheap to get a torque wrench.......

    Cos I'm too cheap to get a torque wrench.... Figure if my rifles are shooting 1-1.5 inch at 100m then why bother getting worried about detail. Argee that there are some wanting better results than...
  2. 12-04-2017, 11:05 PM

    Thread: Torquing stock screws

    by 223nut
    Replies
    20
    Views
    3,393

    Just shaped two stocks tonight, do them up finger...

    Just shaped two stocks tonight, do them up finger tight, smack stock on floor, Put the right bit in the leather an tighten till firm and go shoot shit, job done
  3. 04-04-2017, 03:39 PM

    Thread: Torquing stock screws

    by 223nut
    Replies
    20
    Views
    3,393

    This, and try remember how much 'ummph' it took...

    This, and try remember how much 'ummph' it took to undo and do it the same putting it back together
Results 1 to 3 of 3
Welcome to NZ Hunting and Shooting Forums! We see you're new here, or arn't logged in. Create an account, and Login for full access including our FREE BUY and SELL section Register NOW!!
All times are GMT +13. The time now is 06:11 PM.