:D I will be fine. I was considering a 7.62 x 39 or .300 in a bolt gun, but a semi would be handier for sure. It will be useful out of the machine for a start.
Printable View
Sniper 80 I would like to try amaxs so would like to try your load for 75grn
Thanks nathan
Sent from my SAMSUNG-SGH-I847 using Tapatalk 2
26gr 2206h and 69gr targex do this
http://i1096.photobucket.com/albums/...2751550412.jpg
I found bm2 to give the accuracy edge and shrunk.groups further again to under .2
It would pay to start a grain or so lower and check the load is ok in your rifle. Also check the COAL in your rifle as the throats could be different. Its only a 10min job to cut the back out of a short T3 mag....and so worth doing to get the extra velocity and accuracy.
PM me if you have any ques
Sounds good sniper80 will do
Where are the target projectiles from DS
anyone tried cfe223 in comparison to 2206h?
I had some from the 222 days so tried it, and it worked. It seems to duplicate W748.
People say its dirty, but I have never struck a clean powder so its hard to tell.
I bought a new can of BLC2 the other day, so you can still get it. Regret I did though 'cos I should have tried 2206 which seems to have a bit more fizz to it.
With the BLC2 I'm getting 2900 fps with 69 grn Targex and 20" barrel.
Hell that's not bad for 50 yr old powder!!
I will try some if I can get it easily.
Cheers for that T
I will PM you my load.
http://www.nzhuntingandshooting.co.n...er-loads-4288/