I tested a few factory rounds today (first time I have used any for decades) and was surprised by the ES over 6 rounds.
It was a 22-250 with an average MV (at 10') of 3672fps and an ES of 104fps. Would this be considered normal for factory ammo?
Printable View
I tested a few factory rounds today (first time I have used any for decades) and was surprised by the ES over 6 rounds.
It was a 22-250 with an average MV (at 10') of 3672fps and an ES of 104fps. Would this be considered normal for factory ammo?
yes...and if you go back 30 years ANY spread of less than 50 fps was considered very good going.
when you consider the 22-250 will NORMALLY be usedfrom 0-300 yards...thats not going be miss a bunny material. its still fair honking along.
Fed blue box 55g?Quote:
Originally Posted by Shearer
Hornady varmint express 55gn V-Max.
Sako has the tightest iv seen same as me havent used factory in donkeys
The best I've come across is that cheap copper wash 7.62x39 fmj. That was less than 10 fps. And it shot well too.
But same here, I hardly ever use factory ammo now.
When you are hunting its the first round accuracy thats important. As the barrel warms up with successive shots the POA is going to change no matter what brand of ammo you use .
What does factory mean?Quote:
Originally Posted by Kelton
Sent from my SM-A226B using Tapatalk
Factory loaded ammunition is what im reffering to
Factory ammo does vary quite a bit even lot to lot. 5 or 6 years ago I recall being surprised by some Sako 308 ammo, ES was over 100fps within the same box.
In the weekend I tested some 22 match ammo, within the same packet 3 different rifles ES was 22, 19 and 16 fps. SDs in the 5.7 to 7.2 range. That's fantastic 22 ammo!
Factory ammo has come along way in those 5-6 years I tested some sako ammo a few weeks back a es of 40, some of the factory hornady Prc ammo I was using had a Es of 25, that's pretty good for factory ammo some can't achieve that with handloadsQuote:
Originally Posted by Tentman
Sent from my SM-S916B using Tapatalk
That's what I was wondering. 104 seemed a lot and if I had included the first shot from a cold barrel it would have been 140fps.Quote:
Originally Posted by BRADS
so what is drop difference between slowest and fastest at 300 yards????.....and thats a long way for a 55grn pill.
175 or 180 the 180s not sounding flash so farQuote:
Originally Posted by BRADS
Just ran the figures using a 100 yds zero, a 55 grain bullet and 300yds to target these are the results.Quote:
Originally Posted by Micky Duck
Mv 3650 drop at target from zero 7.8 inches
Mv 3750 drop at target from zero 7.2 inches
Mv 3850 drop at target from zero 6.7 inches
So it looks like a 200 fps spread only makes one inch difference at 300 yds which is likely to be much less than operator error. Note there's no allowance for wind drift but it's likely to be similar.
1 inch....so its still minute of rabbits head.......and the problem is??????
thanks for running the numbers...I suspected it would be something like that
point and splat...lovely cartridge to work with.
Federal 55g soft point 22-250 gave an ES of 10 over 5 shots.