Thread: full size vs neck size

Originally Posted by L.R

Correct I am. If your not then you should get one! I bet you don't do to much full length sizing Greg.

Correct you are not...

I do mainly full length, all be it set up to just having bolt resistance when closing the bolt.

That may be by using a body die & neck die or FL die depending on the calibre, I load a lot of calibres...

There is a big difference between a sloppy factory SAMMI chamber & a custom reamer spec that matches dies.

I have found in the past the only neck sizing has its down falls unless you are careful.

For the "average hunter" FL makes more sense, after all they will most likely lose their brass before they wreck it.