Printable View
Yes. After reading the article on accurate shooter where he cuts a barrel down from 32" to 16" in 2"sections it made me think.Quote:
Originally Posted by 7mmsaum
The speeds he was getting from the 168VLD is basically the same as what I can get out of my 20"708 with 162 amax's.
article here:
http://www.accurateshooter.com/guns-...cat-cartridge/
There's not much info out there though.
Does anyone have any experience with one?
I like the look of a 7mm creedmore over a 7x47 slightly better capacity and could go improved as well though not much of a gain capacity wise. like the x47 the creedmore is considerably shorter than an 08 case and will allow pointy pullets to be seated to the lands even in shorter actions like the model 7 that won't take an extended wyatts mag. If you want to get fancy you can form the brass from lapua .308 and you can even use the palma brass so you can go small primers. It was originally called 7mm GPC. I have a model 7 in 7-08 impossible to get 140 nosler bts to feed out of the mag and get within coo-ee of the lands. I trim the plastic tips with a meplat trimmer so I can get to 50 thou off. If I ever have silly amounts of disposable income I would rebarrel and do it. An expensive proposition by the time you get reamer and dies sorted. I wild-catted a 7 saum mod 7 by shortening the chamber 200, and shortening dies, and getting a form die still cost considerable $