About to give some 9mm a go, how much powder for 124gr? Don't want wussy loads as will probably be used for turkeys.
I hate load development, I'm too impatient
Printable View
About to give some 9mm a go, how much powder for 124gr? Don't want wussy loads as will probably be used for turkeys.
I hate load development, I'm too impatient
3.7gr does around 1040 fps out of my Glock.
What are you shooting it out of?
Cheers
Pete
A factory pistol load would be about what Banana said or a little hotter.
Not sure if pistol loads will be any good in an AR, might not cycle them too good.
Here's the ADI Reloading Data for rifle and pistol.
ADI Powders Handloaders' Guide
Cheers
Pete
my factory and reloaded 9mm Ammo works a treat through both my pistol and carbine ,but I'm using 4.1 "titegroup" with 124g pill which meets my power factor for production 👍
Use ap50, or if you dont like cleaning, use vit n320, 4.0gns (cz would function on 3.2, glock min 3.4, but ar needed a bit warmer, and only wanted 1 load) oh and 124gn rusa projectiles.
The n320 also meters alot better through the dillon ALOT better, so alot quicker and consistant to load.
the lowest i had it was 2.8 grns ap50 .. in my glock/sig ... worked , but was a light load , but with my delicate wrists (thank you scumbag who drove into me) i cant handle too much full loads even of 9mm .... i reackon a decent one is anywhere from 3.5 up ...
Cheers guys, 3.8 sounds like a go then.