6 Attachment(s)
Magnetodspeed "sporter" suppressor mod
Well after getting completely different velocity readings with the same load a couple days apart using my mates Caldwell chrono I decided to mod my magnetospeed sporter so I can use it with a suppressor.
I've found the magnetospeed to be very consistent across different lighting (cloudy vs clear and sunny).
I also figured no point in having it sitting in the draw and using something I don't trust,
I was going to sell and upgrade to the v3 magnetospeed but I would've probably lost a fair whack of $$$ plus had to outlay on the v3.
First up apologies I didn't take any before pics.
But basically followed a video tutorial on YouTube which I'll link in this thread too.
After scribing a line .6" around the top of the base I then used a cut off wheel on my dremel to trim the base down so the whole unit will sit closer to the muzzle line when strapped to the suppressor.
I also cut a piece of bike tube to go between the base and the suppressor as even cut down with the smaller rubber shim they come with I think the muzzle line would still be too high from the magneto ramp.
Anyway here are some pics hope it all makes sense.
Attachment 150513
Attachment 150512
Attachment 150514
Attachment 150515
Attachment 150516
Attachment 150517