If you pull the projectiles from previously reloaded rounds to fit a different type do you need to resize due to possible loss of neck tension?
Printable View
If you pull the projectiles from previously reloaded rounds to fit a different type do you need to resize due to possible loss of neck tension?
Most definitely imo. If have to pull projectiles I will resize the neck just for piece of mind as well.
If you are worried about decapping them again just remove the button and decapping pin.
Sent from my SM-G935F using Tapatalk
Yep I always resize the neck if I pull a projectile as the neck tension will be different
Sent from my iPhone using Tapatalk
Thanks guys for your input re:reloading pulled bullets.
Knocked a few over (not marked :oh noes:), so pulled bullets and powder.
Wasn't sure if I needed to redo necks when reloading ;)
Advice gratefully accepted :thumbsup:
Interesting discussion.
Hadn't thought much about this before because I'd only be pulling a loaded round apart if it didn't chamber in which case it would be deprimed, resized and then reloaded.