pulled Gunworks suppressor apart to clean and didnt look hard enough....the bullet goes thru this way????
Attachment 136924
Printable View
pulled Gunworks suppressor apart to clean and didnt look hard enough....the bullet goes thru this way????
Attachment 136924
Yes, in order to strip the gases away from the projectile
Sent from my iPhone using Tapatalk
Cheers team
The last gunworks suppressor i bought, the blurb that came with it said not to clean it.
how the hell did you get it apart???? unscrew front bit???
HAHA Must have been bored and wanted something to do like us all no doubt :)
its a 6 inch 17HMR one and one end unscrewed.
Some people don't read the instructions :oQuote:
Originally Posted by Tararua Phil
I think you should ask the PM. her rulz gave you the time to play with shit you shouldnt have. hahahah.
Im sure your correct but funny as.
I only run DPTs and they are very " fiddle and play with " but i still dont !
A spray down both ends with INOX and they are good to go
What's the facination with cleaning suppressors? Fired approx 4000 rounds thru Waitaki can on AR before confiscation, still worked ok,was a bit heavier than new. Rifle was still shooting keyhole groups @ 200yds. Haven't put enough rounds thru my Gunworks one to comment but couple of culler's down south just replaced them when replacing their Chinese AR's after in excess of 5000 rounds, getting blocked up but still working. Put about 1000 rounds thru Soni 45 on my replacement rifle.Due to lockdown boredom I undid a couple of baffles just because I could, nothing to dee so probably won't bother again. I also don,t get anal about removing suppressor after use either, barrels seemed to handle it just fine.Don't go overboard cleaning them either. For me rifles are for shooting, not looking at.
there were no pictures so i was stuffed.......Quote:
Originally Posted by Rich007
