Can you tell me what load and oal or comp length
Cheers.
Printable View
26" 1-8 barrel 53.5 gr adi2217 magnum lr primer hornady 2506 brass im pretty unscientific with oal i do the same for all my rifles except my mil 6.5x55s i just start a projectile in the case then chamber it in the rifle close bolt then remove round put in press with seating die wound out wind down so it touches projectile lower ram wind seater down half a turn reseat bullet and keep dummy round for setting up die in future so i dont go off measurements seems to work in my rifles
Good as , I had to do exactly the same method with a new for me 1640 Husky this morning, 30 06 @ 3.340" Coal wouldn't chamber though it would fit the mag, just, so wound in 1/4 till it did chamber @3.272 then blacked it chambered again, no marks so loaded for development.
Thanks.
If the 6.5 in the 06 case behaves like the 6.5/284 then RL22, 2209 and 2213 are your top 3 powders. In the 284 case most blokes are shooting above book max loads. Me included.
A big dose of Belmont's W760 at 40 bucks a can :thumbsup:
Belmont 760, never heard of it. What is it actually?
Ta, Tahr.
Finally out with the H1000, best of naturally, speed up there
Fucked if I know why I cannot get it to load correctly.
Attachment 133942
Attachment 133945
You got to be happy with that group and speed
Yip, some ejector marks on the brass but primer ok and bolt lift ok, Norma brass so a bit soft, half a grain less was an average of 2934 bit more of an Es but that could be neck tension
I'll run the same cases for a few reloads and see how many I'm getting before the primers fall out then if nesseccary back off a bit, maybe take it to 57.2/3
Jeez there is some shite on the net re this round, I wouldn't like to go much further but some claim well in to the 3-3100 for this powder out of shorter barrels, gotta be a load of crap.
Attachment 133946Attachment 133947im not the best shot in the world but you get the idea
Good shit, great rd eh?