Thread: Precision projectile seating

Originally Posted by R93

If I was serious about presses I doubt you could improve on the German Präzipress.

The gauge imo, will tell you considering your brass prep was in order that you would only have to change out the piece of offending brass or remedy it if possible.

I just checked runout and seating on all my loaded 260 improved ammo. It certainly wasnt as good as I remember it was when i did a control check when loading it, however still well within spec.
I dont have compressed loads either.


Sent from my SM-T510 using Tapatalk

Tech Tip: Try Rotating Cartridge During Bullet Seating Process — This Might Reduce Bullet Run-Out « Daily Bulletin