Just pulled a good chunk of bergers and eldx using the old polygrips and reverse press action.
They have a few lines in them above seating depth from the teeth of the polygrips.
I assume they are still sweet for load dev and sighting in?
Printable View
Just pulled a good chunk of bergers and eldx using the old polygrips and reverse press action.
They have a few lines in them above seating depth from the teeth of the polygrips.
I assume they are still sweet for load dev and sighting in?
Go for it.
Oh dear lord...
And I used to think Toby was scary when it came to reloading... :P
Have pulled and re loaded eldx before and never had any issues, in fact the last red I shot at 450 yards was with a pulled projectile that had some damage to the polymer tip and no decernable difference noticed, and yes we shot a few groups on paper to check before using them for hunting
:XD: tikka 260 ha ha ha
Get a hornady collet bullet puller. Makes a near faultless job of pulling bullets for reuse.
More shooting and less pulling would be my advice @Gibo.
sub hundy game loads...no problem ,wouldnt want to trust something with a ding in it at 350...but at 35,jobs done.
Most scratches on the side are most likely put in the projectiles when seating rather than pulling anyway.
@Gibo I have a proper collet bullet puller that does 6.5 and a few other cals. Could be a handy investment at $50