https://i.postimg.cc/c1g1KCzy/IMG-7081.jpg
“Some of my rounds won’t chamber”
Printable View
https://i.postimg.cc/c1g1KCzy/IMG-7081.jpg
“Some of my rounds won’t chamber”
they should all be to spec. lots of fun right there
Good grief
"Neck size only for maximum accuracy"
Espesially if its been fired in another rifleQuote:
Originally Posted by Beetroot
How did the shoulders get that shape with the two rounds on the right ?
"Take the expander out of your sizing die"
Yes, how did that happen? And arriving on a hunt with three different Bullets:huh:Quote:
Originally Posted by 30.06king
Are there any two that are actually the same? Someone has been trying real hard to chamber the two on the right.
GPM.
I suspect the seating die was set too low and was trying to crimp into a non existent groove. The result is a collapsed shoulder like you see. An overlong case can do the same thing when trying to chamber a round.Quote:
Originally Posted by 30.06king
GPM.
Even an old ignoramus like me can see that there would be problems amongst that lot.
Perhaps he intended to throw them at the target species ?? After all they are hand loads?! :wtfsmilie:Quote:
Originally Posted by EmpireSafaris
Is this the brass forming process for a Weatherby wildcat?
The "XXX Fat Mutha Turtle Nek", coming exclusively to a bubba reloading outfit near you. Next week, watch while we rebuild a rifle to chamber it! :thumbsup: