What are some of the tricks to getting a stuck bolt open for a Remington 788?
I think I have found its limit.
Puku
Sent from my SM-G900F using Tapatalk
Printable View
What are some of the tricks to getting a stuck bolt open for a Remington 788?
I think I have found its limit.
Puku
Sent from my SM-G900F using Tapatalk
Not to worry chaps. I got it open
Sent from my SM-G900F using Tapatalk
What was the limit?
Two beers or three:D
Lower than I wanted anyway. Looks like I an going to have to settle on 44 grainsQuote:
Originally Posted by Sideshow
Sent from my SM-G900F using Tapatalk
carefull the bolt handle doesnt break of if you do that to many times
What cal? Nephew has just picked up a budget model 770 in 308 he wants me to reload for.
I'm not sure that it would. The bolt is pretty beefyQuote:
Originally Posted by northdude
308.Quote:
Originally Posted by Marty Henry
Sent from my SM-G900F using Tapatalk
That is only low if velocity is downQuote:
Originally Posted by puku
That is very true.Quote:
Originally Posted by 7mmsaum
I will have to get hold of the forum chrony to see. In saying that though it's only a308 so not worried about speed
Sent from my SM-G900F using Tapatalk
If its a 788 it was known that the bolt handle was separate to the bolt and was welded they were prone to breaking of in your type of situation you see them cheap on tm from time to time with a 2 piece bolt I've got one in 222 one of the most accurate rifles I own
My a old man has one.
Bought in the mid 70s.
It was the first centerfire I fired.
I had the bolt handle come off just cycling it when I was just starting out. They are only braised on.
Oldman re braised it and she has been sweet since.
Sent from my SM-G900F using Tapatalk
Right. I'm off to have a look at this one
Sent from my SM-G900F using Tapatalk
Well @northdude and @R93 I will take your word for it. I can't see any line to identify where the change is but by the look of the design I can guess that it probably isn't all that strong.
I could hope that the sea air and sand has fused it up pretty tight (It's done a few trips to Stewart Island).
The end of the bolt even has a thread on it to line up with the thread on the firing pin housing inside the bolt.
My old man's one has potatoes growing in all the pits but still shoots an inch with good reloads.😆
Sent from my SM-G900F using Tapatalk