Printable View
I've started to shoot a bit of F class just for fun and am looking to get a bit more accuracy out of my rifle, I had it threaded nearly 10years ago through a gun shop. It had 2in cut off so should have been clean rifling, It looks like there was a small counter bore machined into it. Is this commonly done? Any idea if it will have much of an effect and is worth getting redone?https://uploads.tapatalk-cdn.com/201...17c7a34c9f.jpghttps://uploads.tapatalk-cdn.com/201...b376d9bfe1.jpg
Have a look at it closely under high magnification. A jewellers loupe is ideal for that. It anything looks sus, get it redone for peace of mind at least
Fair call, it's not going to hurt to get it done
Do you mean counterbored across the whole muzzle, or just inside the start of the bore itself?
Stick some cotton wool into the muzzle and drip copper cleaner into it. Leave overnight. Then decide what you think of the crown.
Counter bored inside the bore itself, almost like its been hit with a counter sink but way more angle than most.
Tried my best with paint, hopefully its easier to seehttps://uploads.tapatalk-cdn.com/201...a63b3607fb.jpg
I've had a rifle with a crown cut like that and I should mention that it is to this day the most accurate rifle I've ever owned.
If the rifles shoots good, keep it, otherwise have someone crown it again.
Just looked at mine, all have been done that way all shoot well, the 223 tightened up to 1/4 moa after recrowning and is still eye wateringly accurate nearly 1000 rounds later.
How does it shoot now?
No point re-doing it, if shoots well as is.
Shoot it, and dont touch it unless it dont work!
Just trying to squeeze any easy bit of accuracy/consistency I can get out of it.
Its a 223 aswell, shoots alright, consistently groups under an inch usually around half inch at 100. Shot 1.7moa 10 shot at 500 last weekend, 8 would have been within about 1.2
Could be more to do with just being a lite barrel, I am also shooting it without suppressor on for targets just to try keep it a bit cooler and cleaner
I think its fine based on those figures.
Looks weird but it sounds like it works. Lots of weird crowns out there. As everyone has said, if everything is crisp and even it should not matter too much, unless it does, if that makes sense. As you have no obvious problem, why worry. Eliminate everything else first. A re-crown is cheap but you have limited meat left due to the thread, so it would have to come off.
Leave well and good alone , if it deteriorates then look at doing something with it. Sounds as if it shoots primo as it is.
I think keeping the fundamentals of marksmanship in check would be of far more value then any minuscule difference re-crowning that barrel would do.
Or mirror polishing the firing pin and reinstalling with a stronger spring to reduce lock time. Either way, don't touch that nice barrel.Quote:
Originally Posted by Sasquatch
I'm just going to leave the crown as is for now.
I polished the firing pin a while ago when I had some light primer strikes although it turned out to be unrelated.
I think there is a bit more room for improvement in the load, I have changed primers since my initial load development due to availability without any major testing and will look into finding some higher quality brass than the PPU I'm currently using could be worth looking into