Thread: Fixing requirements for E cat safe

also , if I remember rightly it just says bolted in two places as in wall and floor ... I don't think it says you must have two bolts in each ...... I will go find the regs and report back..

ok so it says "should be bolted a minimum of two surfaces , one of which shall be the floor , bolt shafts to be a minimum of 10mm in diameter and when bolted into concrete , expanding or chemical settin g bolts must be used,
where the cabinet is bolted to a wooden floor it shall be through bolted to a steel plate which exceeds the floor area of the cabinet and is retained on at least 2 florr joists ....

there is a little more but this is the minimum ... anything you do over and above this ,is up to you ... if you do the bare minimum then it is fine , .. I will do more just for my own peace of mind , (try chainsawing my floor you fukker) ..... its too bad man traps are illegal ....