Bahaha yeah that was measured from outside to outside.If measured from centre of holes it’s .3
Printable View
Finally got my lithgow .22lr almost to where I want it.
I changed the trigger spring but still not down to 2lbs so will have to get someone who actually knows what they are doing!
So have got it threaded for an over barrel Dan can and a custom bolt knob and trigger spring kit.
I nearly buggered up the nightforce custom rail as had been looking on line and people were talking 55moa rails so decided to run with that.
I had an 5x20 shv but couldn't get it zeroed any closer than 60 yds with subs as only had 90ish internal, I ended up putting an nxs 5.5x22 x50 with zero stop on top with a nf bubble level.
I now can get a 50 m zero with a bit underneath and just checked the internal elevation at 102 moa with 20 in the reticle.
Some would say overkill, I say I could!
A big shout out to nightforce Australia for a bloody nice job on the rail and their awesome scope!
Just zeroed it with some hornady 40g roundnose running at 1070 on the box so will be in for a validation session as reasonably pleased with the cheapish ammo's performance.
Looking forward to some great plinking fun!
https://uploads.tapatalk-cdn.com/201...72a46caeff.jpghttps://uploads.tapatalk-cdn.com/201...fd05a8fad3.jpg
Sent from my SM-G950F using Tapatalk
@Monk
Nice set up on the 300WSM . What projectile are you running? What speed are you getting out of the 20"?
Was thinking similar but was unsure on running 20".
Cheers.
Remington 700 build I did back in 2014 - Thought it deserves to be in the porn section before I sell it :thumbsup:
Attachment 116002
Attachment 116003
Thanks, calibre is in .308 - Specs here
I'm in the process of reducing some of my collection, some of which I don't really have much of a choice now... But fear not, I have a couple of LR rigs similar to this that I will keep. I'll be sure to post them here.
My new 10-22 compiled over a few months buying part by part
Build as follows
Factory Receiver and bolt (don’t see any reason to upgrade ether of these parts)
Factory bolt handle and spring (will upgrade soon though)
Green mountain match barrel (24in) for now
Laminate stock (unsure of brand)
Kidd bolt buffer
Kidd trigger pins
Kidd 2 stage trigger set 8oz 1st stage 8oz 2nd stage
Weaver rail
Burris z rings
Nikon monarch 4-16x50
Attachment 116236