Howdy all
I want to buy a 7.62x39 detachable magazine fed bolt action rifle based on the Lee Enfield.
I know this has been done in the UK,the original barrel and AK magazines were used I believe.
Could be a good seller.
MARK
Printable View
Howdy all
I want to buy a 7.62x39 detachable magazine fed bolt action rifle based on the Lee Enfield.
I know this has been done in the UK,the original barrel and AK magazines were used I believe.
Could be a good seller.
MARK
not sure i understand the point .... if you want a 7.62 x39 in bolt action just buy one if you want to convert a .303 just rechamber , modify the boltface and modify the mag so it takes the shorter round (the added benefit of running heavier slugs)thru a .312 barrel
I had an old beater No1Mk3 that had the barrel set back, rechambered in x39, and fed from a mini 30 magazine.
[EDIT:] Either way you'll be screwed by the big mags with new law coming in. Setting one up inside a modified LE 10 round might be the go, esp if you can use strippers into it
You may soon find that any capacity AK magazines will be banned. Irrespective if it is for a modified bolt action.
The way things are going, writing "BANG" on a piece of paper will be illegal soon
If you want to advantages of both, buy a bullet puller. Load .303 cartridges to 7.62x39 power with all the pleasant advantages of this.
.
yip lets all get on the internet and help create more loopholes to give the powers that be more reasons to restrict stuff.... what you suggest has been done many times before,heck the lee enfield has been chopped n changed into just about everthing with a primer......
keep youe head below the parapet for awhile as there are many out there with high power glassware just looking for something else to take a pot shot at..... lets NOT make it any easier than we have to????
I am going to exercise tongue biting technique from now on.
Speaking of gunsmith challenge. Anyone used aluminium stick welding rods on their AR mag wells?
the challenge will be finding an ar to do it on after everyone has handed them all in plus I bet after all this is done if you all of a sudden appeared with one in any configuration youd get it taken off you anyway wouldn't it be easier to get yourself a howa mini
youd probably warp the shit out of the lower as well
Yes, they work well. Used them to weld up a frame for a new fuel tank on the lawnmower.
https://www.youtube.com/watch?v=n1njyuPBIH0
The stuff is quite hard.
Stick the lower in water and tig a plate over the bottom of the reciever with a five round mag in it.
Its been done many a times, I'm sure. The problem with projects like this is cost. It takes time to do projects like this with lots of R&D involved. Time is money and very few customers are willing to pick up the bill. Normally if something like this is build its done by a friend with time on his hands.
I once worked with a young smith that changed a enfield so it will fire 45 ACP. Lots and lots of manufacturing.
Nothing stopping you from making friends with a hardy good fellow that owns the right tools?
I would rather invest my money in a Howa mini in 7.62x39?