headspace on 308win new barrel

Printable View

06-09-2019, 11:33 AM
lee308

headspace on 308win new barrel

Hey guys, need some advice on doing this little project.
Cracked the factory barrel of the Rem 700 308 Tactical off and replaced it with a Kreiger that was previously fitted to a Rem700.
Trying my luck with the headspace gauges.
Real good fun, Go gauge went fine, and NoGo locked up. Yes, yes, I'm in luck !!
But when I torqued it down.
Go Gauge can't go anymore, headspace too tight? but tried some factory loaded rounds goes in and locks fine.
Shall I try some of my resiezed brass from my redding die and see if it chambers fine?

Where do I go from here, any experts to give me some directions?

Cheers.

Lee
06-09-2019, 11:38 AM
Jaco Goosen

Hy Lee, Im in Paraparaumu. Pm me if you like, I can help you.
Its a fairly easy fix. If you've got the reamer bring it along, otherwise bring just your gauges(I've got everything though).

Cheers.
Jaco
06-09-2019, 12:03 PM
csmiffy

I would've thought less headspace wouldn't be an issue?
I do realise that some factory ammo may not fit properly though.
06-09-2019, 12:19 PM
Jaco Goosen

Sorry. I did'nt read the full post. If the bolt will close on factory ammo your actually lucky and would be able to shoot it that way - please just always keep an eye on the cases looking for preasure signs.

If you only reload it should not be a problem as you can adjust your diameters to suit the chamber, or we can just push the shoulder a little forward to ensure that the rifle is within specs and youll be above board.
06-09-2019, 10:12 PM
lee308

Quote:

Originally Posted by Jaco Goosen

Sorry. I did'nt read the full post. If the bolt will close on factory ammo your actually lucky and would be able to shoot it that way - please just always keep an eye on the cases looking for preasure signs.

If you only reload it should not be a problem as you can adjust your diameters to suit the chamber, or we can just push the shoulder a little forward to ensure that the rifle is within specs and youll be above board.

Thanks for the reply, I really appreciate your information. I have found that my Redding fl bushing die sized brass won't chamber and my RCBS FL Die resized brass will chamber but still a bit tight. It might be to do with the shoulder resizing.
i'll keep trying and see.
07-09-2019, 02:17 AM
Jaco Goosen

Offer still stands and if there are any other questions dont be afraid to ask.

Cheers