Is there a way to "lock" a collapsible AR-15 stock so it can collapse a little bit but not fully? (For an sbr to not go less than 762mm)
Printable View
Is there a way to "lock" a collapsible AR-15 stock so it can collapse a little bit but not fully? (For an sbr to not go less than 762mm)
https://www.strikeindustries.com/sho...tock-stop.html
Sent from my SM-A510Y using Tapatalk
Is there a solution in New Zealand ?Quote:
Originally Posted by Banana
Yes.Quote:
Originally Posted by Square22
I used a section of plumbers pipe. Cut to correct length and put in stock. Easy.
Any chance you can post a couple of pics please?Quote:
Originally Posted by Beaker
Or a piece of dowel in the back of the stock. Wrap it with electrical tape so it fits snug and push it in.
A small hole and a roll pin through the stock to contact the back of the buffer tube also works, esp on the sorts of stock which don't have a blind hole
Slide stock off, cut a bit of this pipe the right length, Attachment 91145Quote:
Originally Posted by Square22
Drop it inside stock, put stock back on buffer tube.
Right length was about 50mm.
Thanks manQuote:
Originally Posted by Beaker
@Square22,
Unless you are of small stature or else usually shoot wearing body armour / heavy winter coat, you may benefit from the extra inch or more that a recoil pad gives. Maybe that's enough to stay above the magic 762mm, without sacrificing a cool clicky clacky stock feature. But good advice given above.
This.Quote:
Originally Posted by Cordite
I like a long stock(long arms), but wanted a short barrel, the combo of locking stock and big pad, did the length thing.
