Thread: Remington accuracy

[QUOTE=CamFlatt;835684]I checked everything over and all seems tight and snug. Turns out the rifle is not free floated though. Do I (carefully) use a grinder to remove plastic right down the channel, including the two nubs at the end?
On pillar bedding will JB weld suffice? Can someone link me a good guide to follow?

Unless you're going to bed the action don't grind out the stock. Remington's are fitted at the factory with forward pressure between the stock and barrel to aid with consistency. If anything you may need to put in a shim of some kind at the front to give it more pressure.
Fitting the magazine box back properly may well have been enough to regain some consistency.