I have a Sako 75 wood stock here that has dried out and needs re-finished.
Someone gave me a recipe for re-finishing it a long time ago and I have lost it. Thread is buried here somewhere.
Hoping that someone is still about.
Printable View
I have a Sako 75 wood stock here that has dried out and needs re-finished.
Someone gave me a recipe for re-finishing it a long time ago and I have lost it. Thread is buried here somewhere.
Hoping that someone is still about.
I’ve used tru-oil on my stocks. It’s good for modern rifles when rubbed on and levelled out with fingers. I put x10 coats on my last stock. If too shiny, use a worn green pot scrubber to knock the gloss off, when product dry.
I have tru-oil, but actually prefer lots of layers of boiled linseed finished off with Danish oil.
That will be similar to what I want to do next time.Quote:
Originally Posted by dogmatix
Only use Danish oil though with maybe a touch of alkanet oil for some reddnes
Danish oil. But as @mimms2 said. I personally prefer a fine scotch pad because it cannot leave behind anything that causes rust.
I also like to soak the first couple coats on before scotch brite, assuming there isn't any contaminants in those coats. Then lots and lots of very thin coats, it sucks and takes time but feel it's worth it. Also be prepared for wankers.....ahhh tennis elbow. The more you rub it in fine layers the better.
Damp the stock after cleaning and hit it with hairdryer or heat gun (careful with heat gun) and you will probably be surprised how much grain raises. Although hopefully not much with a Sako.
Good time to steam out any little dents too. Tru Oil in barrel channel and butt/grip areas only for me. It works well but I prefer the hand rubbed with oil look on the body of the stock.
tru oil then polish out with a nylon pad, then birchwood casey beeswax over the top. gives a nice satin finish and very easy to hold the rifle when its wet
If you want to find a thread here go straight to google.
I might go the basic route.
But check out @Sideshow recipe.
https://www.nzhuntingandshooting.co....54/index3.html
I'm taking a punt here.
Some of these wooden stocks used to walk a bit with temp and humidity.
This one is old now. The walnut is very settled and it's been in the cupboard, very dry, for years. No use.
A big thing here is to seal the whole thing very tight so that core stays dry and stable. I think I will start with thin diluted tru-oil and try and get it to suck it in deep, then layer coats in, getting thicker as I go.
Going to start with very very very fine sandpaper (after washing with solvents) and then go to the green pot scrubs mentioned and spend time rubbing it down while sitting about in the evening (not that I do this much).
It's a nice piece of wood.
I will get the checkering tidied up by Carlsen Highway.
I was going to suggest TJ, but Carlsen is certainly closer to you.
Should add, I meant Tru Oil under recoil pad/grip cap and barrel channel not on butt and grip.
Also @Tussock I be keen to see how it turns out if you feel like putting up pics when you done.
Good point. This is what I mean by wanting the whole thing sealed.Quote:
Originally Posted by Preacher