Thread: Talley ring height for Tikka

What height rings in the Talleys do you find gives best cheek weld on the new Tx3?
I am unlikely to use a scope with anything bigger than 42 mm objective,most likely a 36mm.
So Im not too worried about clearance but more concerned if I go extra low it might be too low for natural alignment of stock,cheek and eyepiece.
I do realise there are a few variables here,but am interested in what you find works.

If a factory stock extra low.
But the depends on the scope I have a Burris 3-15 HD and it needs medium for the rear lense to clear the action.
Z5 or vx5 extra low

Sent from my CPH2531 using Tapatalk