3 Attachment(s)
Vx3 zero stop mod any tips or advice ?
So I have a vx3 4.5-14x40 CDS and I'm looking at doing the zero stop mod that I've seen on here.
Anyone who has done this got any tips or advice ?
Looking at my dial and scope if I install either a plastic post or ball bearing in the hole that is pre drilled in the cap it will mean my "zero" is effectively 3 clicks up so that it will allow 1 full rotation (60 clicks) before hitting the stop
Attachment 109703
Attachment 109704
Attachment 109705
So if you see the stopper on the scope it sits directly in line with the indicator mark on the scope body.
I seem to remember reading somewhere the piece the stopper is on is press fit. So could I lever it off and move it around so the the ball bearing or post can be fitted to the cap and then allow the zero to sit on zero ? Hope that makes sense ?
Also can anyone advise the best option for a ball bearing or plastic post to fit into the cap ?