Who owns a hells canyon?

I have put together a 300prc hells canyon with the heavier barrel.
Put Talley rings and bubble level with nx8 with a stealth can on it.
I'm shooting factory 212 precision hunter to get brass for reloading to then load with 230 atips.
Is there anybody that has a hells canyon in that caliber reloading or got a verdict on accuracy and a lighter trigger spring?
Cheers Andy

Sent from my SM-A226B using Tapatalk

Owned one in 7mmRM it was super accurate. I put a $380 Timney trigger in mine, much nicer!

You won’t need that Sako now……….

:)

Quote:

---

Originally Posted by TroyMclean

Owned one in 7mmRM it was super accurate. I put a $380 Timney trigger in mine, much nicer!

---

I'm thinking the same thing!
Did you go timney?

Sent from my SM-A226B using Tapatalk

Quote:

---

Originally Posted by 7mmsaum

You won’t need that Sako now……….

:)

---

Sad news for you, I'm setting up for a mate so the varmint stays!

Sent from my SM-A226B using Tapatalk

They are buggers of things to get the scope level with the action, and the triggers don't go to 3lb like they say.
Other than that I like the build quality and the look of the rifle. https://uploads.tapatalk-cdn.com/202...c1733ff2aa.jpg

Sent from my SM-A226B using Tapatalk

At bloody last on this forum - A picture of a bench that resembles mine - if only in terms of clutter!

@andyanimal31 .Would have looked better with a brown scope[emoji6]

Sent from my SM-G525F using Tapatalk

Andy , to get a good flat reference, remove the action from the stock and use the flat part under the action. Or the flats on the side with a square set along them.

The newest x bolt that will come in the country will have a flat reference milled just behind the rear bridge.
And the threads will be more common stuff than the shitty threads currently offered on the thinner barrel models.

Quote:

---

Originally Posted by hunter Al.7mm08

@andyanimal31 .Would have looked better with a brown scope[emoji6]

Sent from my SM-G525F using Tapatalk

---

No way I wanted a nightforce to be mistaken for a vortex and have my integrity questioned!


Sent from my SM-A226B using Tapatalk

Quote:

---

Originally Posted by Friwi

Andy , to get a good flat reference, remove the action from the stock and use the flat part under the action. Or the flats on the side with a square set along them.

The newest x bolt that will come in the country will have a flat reference milled just behind the rear bridge.
And the threads will be more common stuff than the shitty threads currently offered on the thinner barrel models.

---

I tell ya what, it makes you appreciate scoping up a tikka!
I will put a photo up of the model on the box, you might be able to decipher it for me.
There is a small flat section at the back of the bolt that I used as a reference point.
All good to go.
Wasn't that happy with the first few shots but deep cleaned it and quite a bit of carbon and copper come out.
I will be interested to know if they have an accuracy guarantee.
I will be spewing if I need to use one!https://uploads.tapatalk-cdn.com/202...026924f96e.jpg

Sent from my SM-A226B using Tapatalk

Quote:

---

Originally Posted by Tentman

At bloody last on this forum - A picture of a bench that resembles mine - if only in terms of clutter!

---

That's about as good as it gets!https://uploads.tapatalk-cdn.com/202...9aeb056456.jpg

Sent from my SM-A226B using Tapatalk