Cutting a thread into flutes of barrel

Hi

3 questions:

1. I have a 243 finnlight and want to shorten the barrel to 18 inches (or less) and put a Dan Can on it (Gen 4). this will require cutting a thread deeper than the flutes. Will this mean going too deep into the barrel and i get barrel expansion and potential loss of accuracy (or is this bullsh*t?).

Dans suppressor is 80 mm ahead of the barrel so cutting 50mm gives me a net gain in length of only 30 mm. I'm not worried about a bit of velicity loss and the suppressor will be a permanent attachment so couldn't care less about the flutes going to the end of the barrel.

2. Do you think their will be enough "meat" left at the thread end of the barrel to rebarrel to 7 08 and not end up having very little barrel left? (hope that makes sense!)

3. Will a 7mm suppressor (in preparation for a rebarrel) adequately suppress the 243?

Cheers

Tom

Don't think that 'permanently on' is a good idea, you run the risk of corrosion at the muzzle if it's not taken off at all. . .

I've had a Finn threaded though I didn't shorten the barrel,are you sure there is a need to as your already at 20" for the 243..

You're right. I meant it will be hunted with the suppressor on and removed for cleaning / storage etc.

You already have a perfectly good 7-08. Don't fuck a perfectly good calibre (243) and have two of the same gun.

What would you know James??

I had Dan shorten and can a fluted R15 barrel and it wasn't a problem for him.
The 7mm can will be fine

Buy a DPT can instead for a fraction of the price !

compared my hardy ar can to my mates dpt can and the dpt was a mile quieter!

if your wanting it as a bush rifle idea its not such a bad idea but as an idea, buy one of remingtons new carbine in 300AAC which has a 16.75" barrel instead?or a ar in that cal? or are you absolutely dead set on your 243?

This might work for you and save your origonal barrel:

http://www.nzhuntingandshooting.co.n...rel-used-4840/

Quote:

---

Originally Posted by Ginga

What would you know James??

---

More than you dumb ass

Quote:

---

Originally Posted by kiwijames

More than you dumb ass

---

Good on ya James :thumbsup: