Printable View
Busy inletting a stock for AICS DBM, so have AI mags on the brain at the moment.
Watched some vids about "tuning" the feed lips on the mags so they have similar/consistent tension.
Quick trip into the workshop tonight to make this little tool. Both mags adjusted to have 0.415 gap, easy peasy.
Attachment 94054
Life before a lathe & mill was a lot less interesting :thumbsup
sure beats the adjustable cresent I use to rebend my poor old fert truck after it has tried to digest a guts full of rocks some dipstick put into the lime pile.
Hmmm, nice little ummmmmmmmmm thingo. :thumbsup:
Its good being able to knock up some gadget out of not much that help solve some small problem
Fine feed lip adjustment wrench
or
Precision feed angle adjustment plier:thumbsup:
