Following with interest. Gotta do similar to a truck chassis for a slightly large house truck setup.
Following with interest. Gotta do similar to a truck chassis for a slightly large house truck setup.
@Happy, me and the wife really want to see some photos of the inside please, that trailer looks farkin perfect for a two person bunk.
Attachment 184452Attachment 184453Attachment 184456
Still working away at it, just put on 480w of solar and some Lithium batteries in it to run the fridge that my wife demanded.
Still a lot left to do but will be able to sleep in it for some xmas camping.
It's been quite a learning curve.
Looks good but why no windows?
Gee its flash Savage1, much bigger than I thought from the earlier photos of the chassis. Is the edge trim a freezer panel extrusion or is it a heavier gauge Ali angle iron rolled to fit ? great protection either way
It has a 6.8m body, panels only came 6.5m long hence the join near the front.
It's a 75mm Ali angle extrusion, 50mm on the interior joins too, all glued and riveted. Couldn't get anywhere to roll the curves so I fabricated them, it was a right PITA.
Bostick IMR glue is pretty much all that is holding it together, I think it's the same stuff that holds windscreens in cars.
Attachment 184717Attachment 184718
Not bad for its size and fully laden apart from empty water tanks. Kitchen, beds, solar, batteries, fridge, cabinetry/cupboards all installed, just needs windows, toilet and shower installing now
Gives it 1800kg to play with before it's over loaded.