Thread: Securing an E-cat safe...

so , what I did was add some 18mm thick ply in the back of the closet and screwd it into the studs , and just screwed the safe onto that , its only to stop thieving scum from pulling on it and using it as a lever to break your bottom bolts ..... for the bottom I welded up a large section of angle iron that spanned at least two floor joists under the hosue (stops the thieving scum from chainsawing it out easily) , and bolted the safe to end and welded the bolts as well ...... mine is a b and e safe , ... and the vetting officer was happy with it

I guess you can do the same on the side of the closet , ... say goodbye to the skirting in there , so the safe goes hard against the wall , good luck