Anyone got one they don't mind loaning me? Happy to cross your palm with silver or a bottle of your favorite
Printable View
Anyone got one they don't mind loaning me? Happy to cross your palm with silver or a bottle of your favorite
That's a no I take it :)
I missed the auction with no auto bid! Did you buy them?
$75 should raise the dents.a competent gunsmith shouldn't charge much more.there is a bit of a skill.near enough is no substitute for an expert repair.a good man makes it look simple.
To be honest I couldn't take this to a gunsmith. It is a project and I'm quite keen to have a crack myself. Considering I just relayed a rib on it I think knocking a dent out will be easy :)
Just turned up a 16 bore mandrel today at lunch, may as well follow the midway videos and make my own
i see you are a man of skill.the video's are good. there is an excellent article by howe "the modern gunsmith" vol 2, p346 on removing dents from barrels.i could scan and send if you require.it has all the designs to make a dent raiser.
I know this young guy in Wairoa with a hacksaw, grinder and arc welder that could make the pheasant slaying machine!Quote:
Originally Posted by Pointer
I wouldn't go that far in regards to the 'skilled' comment lophortyx, its just that I have a grand total if $120 invested in this old underlever 16 bore, and I don't want that number to change considerably :D
And Toby that young guy in wairoa would turn it into a bank slaying machine if he had his way. Ten points for a stylish burglary though, using a sawn off hammer gun!
Attachment 39801
Excuse the sideways pic. Turned up a replacement firing pin while I was there
according to howe that metal.must be soft and polished so as it does not mark barrels. good luck.
where do you put the batterys in it is it multi speed :)Quote:
Originally Posted by Pointer
Yep. Multi speed and waterproof. Guaranteed to straighten ya bore out!
make a split one with a thread that pulls a ramp into the gap and do it that way
Yep that's exactly what I have done as per the midway videos. The pressure of the ramp was enough to lift most of the first dent, takes a lot of hammer work out of it. I also found a rawhide soft face hammer much better than the suggested brass hammer. Although it takes longer it doesn't mark the surface, so no need to sand which is a massive no no on a Damascus barrel
