Tired of eating venison, ah first world problems. I love it!
Liked On: 12-06-2015, 11:24 PM
You could go hunting with a mate and have them shoot it and carry it! :thumbsup: You could replace the projectiles in your 300WSM with wax - reduced projectile weight means reduced recoil and wax...
Liked On: 12-06-2015, 11:09 PM
I had a shoulder rebuilt twice 7? Years ago, it has 21 screws in it!! I found recoil very painful for the first year, did rather well shooting left hand for while but difficult with everything on the...
Liked On: 12-06-2015, 11:08 PM
The best ways to decrease recoil is to increase the rifle mass, reduce the projectile mass and velocity, use a muzzle brake or a suppressor. What recoil pad do you have? Limbsavers work well to...
Liked On: 12-06-2015, 11:08 PM
Shoot small animals at closer ranges with smaller calibre rifle! :thumbsup: Small animals will weight less - more so when you bone them out on the spot and only take the meat! A smaller calibre...
Liked On: 12-06-2015, 11:07 PM
Put a tight fitting patch on a jag on your cleaning rod, mark a line up the rod,insert into barrel and mark it push further watching the line on the rod till it has done one full turn and mark the...
Liked On: 12-06-2015, 11:06 PM
The Hawkes Bay Rifle Club was formed in 2008 from the remnants of the Okawa Rifle Club, Napier City Rifle Club, and Waipukurau Rifle Clubs, after the closure of the army rifle range at Roys Hill near...
Liked On: 12-06-2015, 11:21 AM
Best you drive it and see for yourself if it ticks your boxes.
Liked On: 10-06-2015, 11:00 PM
Moorer and betterer are always gooder
Liked On: 10-06-2015, 09:12 AM
A lot if cheap enough. H and S would be a big thing for the land owner no doubt
Liked On: 10-06-2015, 09:12 AM
thoughts on frequency of use and willingness to pay if one came available ie 20 mins - 30mins from nelson town
Liked On: 10-06-2015, 09:12 AM
And I could possibly pay money to watch that procedure :D
Liked On: 10-06-2015, 09:12 AM
I can put holes in it for the same fees :thumbsup:
Liked On: 10-06-2015, 09:12 AM
I could supply steel at a very reasonable rate for lack of range fees :thumbsup:
Liked On: 10-06-2015, 09:12 AM
Shit I'm at the wrong range:P
Liked On: 10-06-2015, 09:11 AM