i will see if can find the last thread on this and link it...... and please tell me this....if your die and base are already touching..how could you POSSIBLY bump it further???? you cant.......
Liked On: 12-08-2023, 08:56 PM
Looks like some rub marks a cm or so up from the base which suggests you are not getting full resizing last cm or so before the head. I think I’ve got some Redding 7mmWSM dies if you wanted to borrow...
Liked On: 12-08-2023, 08:48 PM
If your trying to use brass not fired in your rifle as well as the datum point measurement it is useful to measure the base diameter 0.1 up from the base and compare. I have second hand brass that...
Liked On: 12-08-2023, 07:26 PM
Greetings again., Touching the shell holder is not the same as hard down on it. There is spring in all the linkages that will result in an undersized case as I found out over 40 years ago. The...
Liked On: 12-08-2023, 06:53 PM
Greetings BenTheBuilder, I too have been there. There are two measurements that you have not given us that will help. 1. The length of a case to datum that has been fired in your rifle, and if...
Liked On: 12-08-2023, 06:52 PM
BenTheBuilder Something to try before further die or shellholder adjustment. Brass has a bit of natural "spring" in it. In a FL Die it gets sized down and often "springs" up a little in size again...
Liked On: 12-08-2023, 06:52 PM
the very first step...and its bloody hard to help you UNTIL you do it...is to get a felt tip vivid and totally clour a tight fitting round...all over including projectile...chamber it and then work...
Liked On: 12-08-2023, 02:59 PM
I would draw all over the resized case with a vivid/sharpie/highlighter. Then try chambering it, then look for rubbed of ink on the case. Should tell you where the contact point is. If it's rubbed on...
Liked On: 12-08-2023, 02:58 PM
Here's a couple of things. If you are right handed take the back steaks out from this direction (in pic). Make your first cut right along hard against the back bone and then start from the front...
Liked On: 12-08-2023, 02:33 PM
Dont know if you already do it but always make your skinning cuts with the knife blade upwards cutting from underneath the skin , you will get half the amount of hair coming out that way.
Liked On: 12-08-2023, 02:27 PM
230892230893, Glad you like it. Designed primarily as a skinning knife. Made from AEB-L stainless steel. G10 bolsters and liners. The second picture is mine about to be put to work.
Liked On: 11-08-2023, 07:37 AM
bluebaiter - that problem would soon enough be over if they put him in general population I prefer SI I have no obligations or steadfast plans except 1 Oct, be on some backwater probably in the...
Liked On: 10-08-2023, 09:03 PM
Lucky that ear plug was there when you kneadedit........ i'll see myself out...
Liked On: 08-08-2023, 06:56 PM
yes
Liked On: 07-08-2023, 10:22 PM
Here you go.... note the last line [emoji106] What is a triggering event ? Purchasing or selling a firearm Change of address Obtaining a permit to possess Obtaining an import permit...
Liked On: 07-08-2023, 05:35 PM