Hi NzMavrick, just to help you along on the forum. Firstly this kind of post has been posted before and the response is always the same. No one is going to recommend you or tell you a spot to...
Liked On: 20-12-2020, 01:46 PM
Bill999 I had another go. Polished the cocking cam alot more aggressively, mirror finish. Then I applied a heap of moly grease on every moving part of the gun. Significantly improved the feel. I...
Liked On: 20-12-2020, 01:12 PM
Hello all, I'm Luke and I live in Far North Qld Australlia. I am currently building a 243AI on a Sako 85 action using one of your amazing True-FLite tubes. I'm pretty excited to be honest. I...
Liked On: 17-12-2020, 07:25 PM
This is the reason I'm not really upset. Sent from my CPH1701 using Tapatalk
Liked On: 12-12-2020, 04:05 AM
After brining a soak in milk for an hour or so works further wonders with rabbit's
Liked On: 10-12-2020, 08:41 AM
Brine rabbits. Skinned and gutted and straight in the brine. Brine concentration is not important, I throw about handful of salt in about 4L of water. Ready to eat about 24hrs later Its a...
Liked On: 10-12-2020, 08:40 AM
took the advice of Sarvo & have purchased a nice wee section in the Pelorus sounds. Thanks for the help fellas. Dave
Liked On: 09-12-2020, 01:43 PM
All of the above, but it also leaves the sling stud available to attach a bipod without having to remove the sling first Sent from my iPhone using Tapatalk
Liked On: 08-12-2020, 08:48 AM
As most know, Lee Enfields are not know for their hair trigger, in deed, they are meant to be set up to have a two-stage "creepy first-then-harder crisp" trigger. Anyway, the best set up trigger...
Liked On: 08-12-2020, 08:03 AM
The acid etch removed all the loose scale and cleaned out all the rust in the forging pits which was not the look I wanted so I decided to re rust the blade now it was etched so the pits would look...
Liked On: 08-12-2020, 08:01 AM
Patience is a virtue so they say and I have certainly been virtuous :D Defiance deviant ultralight fully nitrided with blind bolt release pin in "XM" lenght. Defiance alloy bottom metal and...
Liked On: 07-12-2020, 01:09 PM
Mines got the beretta kickoff system same as in your link. I don’t think it makes much difference, but I’m also not too bothered with recoil. When I run 3.5inch crackers it kicks like a mule and...
Liked On: 05-12-2020, 02:21 PM
Hi guys, you asked if a retiree could make bullets for a bit of pocket money & I would say yes to that one but you have to realise there is quite an investment in presses,dies & jackets so its no use...
Liked On: 05-12-2020, 11:49 AM
223...
Liked On: 03-12-2020, 01:17 PM
Mmm, that Bryn. The same one that is running a logging gang over Summer & does cabinet making & rifle stocks etc over winter as there will never be enough money or quantities required in nz to make a...
Liked On: 02-12-2020, 09:22 AM