That screenshot says Impact Point (in), then up 2cm, so could be inches rather than cm
Liked On: 29-09-2021, 01:44 PM
I use an expanding die when loading cast bullets. It flares the mouth of the case and avoids the bullet being shaved as it’s seated
Liked On: 29-09-2021, 10:54 AM
I use an expanding die when loading cast bullets. It flares the mouth of the case and avoids the bullet being shaved as it’s seated
Liked On: 29-09-2021, 10:26 AM
That screenshot says Impact Point (in), then up 2cm, so could be inches rather than cm
Liked On: 28-09-2021, 08:29 PM
Firing pin jamming in hole in bolt face, because it moves further forwards with no primer to stop it?
Liked On: 24-09-2021, 08:16 PM
Seen people do the same at Marokopa. One crew has a flat trailer made from a chiller panel. Tow it to the river with the quad, drive quad on, walk/swim it over river. Some people just use a dingy.
Liked On: 23-09-2021, 06:34 PM
Firing pin jamming in hole in bolt face, because it moves further forwards with no primer to stop it?
Liked On: 21-09-2021, 10:59 PM
Firing pin jamming in hole in bolt face, because it moves further forwards with no primer to stop it?
Liked On: 21-09-2021, 10:08 PM
I neck size with Lee collet dies because supposedly it gives longer case life, and I don’t need to lube (then clean again) the cases. I full length size after the fifth loading. Brass for the lever...
Liked On: 15-09-2021, 10:09 AM
Yep, and supposed to turn darker as it dries.
Liked On: 14-09-2021, 08:48 PM
I don’t look at different sections on the forum, I just hit the new posts button so I get a list of all the threads with new posts, then open and read the ones that interest me.
Liked On: 14-09-2021, 10:12 AM
Are we still talking about knives? ;)
Liked On: 08-09-2021, 06:27 PM
Are we still talking about knives? ;)
Liked On: 07-09-2021, 07:15 PM
Are we still talking about knives? ;)
Liked On: 06-09-2021, 10:00 PM
Are we still talking about knives? ;)
Liked On: 06-09-2021, 04:38 PM