Is it wrong that I read it and didn't realise until the second line he was quoting my thread :yaeh am not durnk: :D
Liked On: 12-08-2023, 05:27 PM
was about to suggest the same, or just cut a piece of stainless or brass rod of the same diameter and press into place (could use epoxy to hold in place if need be)
Liked On: 12-08-2023, 02:48 PM
was about to suggest the same, or just cut a piece of stainless or brass rod of the same diameter and press into place (could use epoxy to hold in place if need be)
Liked On: 12-08-2023, 02:32 PM
Today was a bit of a bust.....spent the morning trimming back the remaining bits of the wellside then stopped for lunch after which i figured I'd test fit the xr6 seats......this did not go well...
Liked On: 12-08-2023, 01:16 PM
definately not.....it's a learning experience. I have just enough mechanical knowledge to be detrimental to my bank balance.......I have some very handy friends and I help them with labour they help...
Liked On: 11-08-2023, 10:41 PM
Today was a bit of a bust.....spent the morning trimming back the remaining bits of the wellside then stopped for lunch after which i figured I'd test fit the xr6 seats......this did not go well...
Liked On: 11-08-2023, 10:36 PM
drove around my fair share of safari's, Landcruisers and landrovers in my old Zook.....it's Achilles heel was also it's strongest atribute (lack of weight) it was great as it didn't sink in the boggy...
Liked On: 11-08-2023, 08:30 PM
Manuka Custom :thumbsup:
Liked On: 11-08-2023, 08:52 AM
drove around my fair share of safari's, Landcruisers and landrovers in my old Zook.....it's Achilles heel was also it's strongest atribute (lack of weight) it was great as it didn't sink in the boggy...
Liked On: 11-08-2023, 12:11 AM
Correct, but not as much as normal and a couple of those were under spotlight. I'm confident it's a good load and I'll keep using it.
Liked On: 10-08-2023, 02:11 PM
5 or 6 out to 400y all dropped on the spot, haven't been doing much hunting lately due to no spare time :oh noes:
Liked On: 10-08-2023, 12:46 PM
168gn eldm's have been very successful I my 22" Lupo over a mild load of 2208 have to check my charge weight again but its only a mild load at 2622fps, super accurate, super easy to get shooting sub...
Liked On: 10-08-2023, 12:45 PM
168gn eldm's have been very successful I my 22" Lupo over a mild load of 2208 have to check my charge weight again but its only a mild load at 2622fps, super accurate, super easy to get shooting sub...
Liked On: 09-08-2023, 11:18 PM
definately not.....it's a learning experience. I have just enough mechanical knowledge to be detrimental to my bank balance.......I have some very handy friends and I help them with labour they help...
Liked On: 09-08-2023, 12:16 PM
I just wanna drive it soooooooop baaaad :yuush: :psychotic:
Liked On: 08-08-2023, 10:31 PM