130405 I liked the light weight and toughness of the svord... But it was clunky, the handle was bigger than needed, and the top wasn't that usable for me... So reshaped the tip, thinned down the...
Liked On: 11-02-2020, 07:35 PM
I have a VX3i 4.5-14x40mm (1inch) on a Tikka with Talley Extra Low rings.
Liked On: 11-02-2020, 07:34 PM
Ashburton has a range out to 700 yards its at Range Road Ashburton they are very helpful and accommodating they shoot most Sundays 13:00 hours start. I think they are on facebook I am not so have...
Liked On: 11-02-2020, 03:26 PM
130378 Latest knife finished, Mamba model, native timber stabilised handles , black G10 liners. Full grind 14c28n sandvik. 4.5 inch blade. Off to a forum member, thank you for the support. ...
Liked On: 11-02-2020, 01:54 PM
For a bit of variation to stews with necks, shanks and shoulders, slow cook them with a tin of Pataks or your favourite vindaloo paste. Guarantee you will carry these cuts out after trying it and not...
Liked On: 11-02-2020, 07:37 AM
I have just got back from a few days spent in the Nelson Lakes area and will let the pictures do the talking. 130344 A few showers on the way in. 130345 130346 They couldn't figure out where the...
Liked On: 10-02-2020, 09:25 PM
And no I'm not talking HGD, he gone Went for a hunt on the weekend and as I was scaling down a slip I noticed a time in the grass and un earthed this Hamish Sent from my SM-G960F using...
Liked On: 10-02-2020, 09:23 PM
Sounds like a sharp edge to me, and less bearing surface grinding paste will probably just make it fit sloppy. Removing more material should be done very carefully from this point on
Liked On: 10-02-2020, 08:29 PM
Even if only the bolt it would have been a prior problem as they would be taking metal off not adding it on.
Liked On: 10-02-2020, 07:45 PM
What if you already have a good poo each morning?
Liked On: 10-02-2020, 07:36 PM
The T1x 17hmr cleaned out a few more pests from the berry orchard last night. I've shot a lot of rabbits off this one little property in the last couple of months. Not many left...
Liked On: 10-02-2020, 02:23 PM
Good job done by Gunworks. 130313 I have to say it does make the rifle look much hotter. Performance wise, the original finish is smoother. After the fluting done, I can feel a little bit of...
Liked On: 10-02-2020, 02:21 PM
I thought the same thing while gutting a deer the other day. Gave it a quick once-over... For newbie/townies like me though, it would be good to have a photo catalogue of what to look for. I have no...
Liked On: 10-02-2020, 11:19 AM
Gonna have to have a go at this removing it from the inside thing, I always just go straight in, incision down the stomach and around the bum, come up other side and remove pizzle or vagina and udder...
Liked On: 10-02-2020, 10:59 AM
I’ve been using them in a 7mm08. Its not my main hunting rifle so I’ve only shot a dozen or so animals with them but I have yet to have a result to make me question their performance. I’ve used...
Liked On: 10-02-2020, 09:42 AM