love my swed, 140 amaxes have taken down anything iv shot at a little more speed would be nice for 1000 plus shots so will be following this ai thread with interest
Liked On: 20-04-2014, 06:29 PM
Understood Bagheera and thanks for the reply, another good reason for having adjustable focus over fixed, and the decision has been made and I've opted for adjustable. Now I need to confirm...
Liked On: 18-04-2014, 09:10 AM
One more thing .. when I'm testing my loads I ALWAYS use a bipod and rear bag. I KNOW this is not how you shoot in the bush, but you're testing the Projectile and load here, not your shooting...
Liked On: 15-04-2014, 10:42 PM
This is what I use,SPUHR MOUNT,love it! Notice the inbuilt bubble?22841
Liked On: 13-04-2014, 05:01 PM
10 is not enough to zero and validate drops at longer range, just buy a packet of 50 or a hundred of lots of brands and get shooting. They are not that expensive in the grand scheme of things and...
Liked On: 12-04-2014, 10:22 PM
Hi all. I am Scott, new member of this forum. It is nice to be a part of this forum.
Liked On: 09-04-2014, 08:17 PM
Make up a target with 1" grid lines, ideally 20" total but 10" is the minimum. Clamp the rifle with the cross hairs precisely on the top mark. Wind 10 MOA into your scope and see how far the cross...
Liked On: 02-04-2014, 09:35 PM
Useful post..... :wtfsmilie: Care to share, or are you just leaving it there ? I use tall target for 2 things. One to check cant / scope level. Two to see the real value of clicks - contrary to...
Liked On: 02-04-2014, 08:33 PM
I see you are located in Auckland...if you could do all your possum shooting in a northerly direction I would be most grateful.
Liked On: 02-04-2014, 08:21 PM
If the bolt still functions then don't bother replacing it, there is an old fella at our local NRA range that has a perfect ring on his bolt face from it happening so much and his rifle is a fricken...
Liked On: 19-03-2014, 07:38 PM
Yep mate they totally fucked the face of the bolt head on my long range rifle (severely pitted the face and welded the ejector pin to the bolt head) and I have been out of commission for over four...
Liked On: 19-03-2014, 07:37 PM
I asked my club armourer and he's saying he thinks its possibly the old batch of winchester primers that came in and did this some years ago now being sold again due to the shortages. Certainly if...
Liked On: 19-03-2014, 07:36 PM
Lol, that took longer than i thought it would.
Liked On: 15-03-2014, 04:17 PM
Subscribed, this should be good! Personally, in my Tikka M595 .243 I don't use copper removing bore solvents. I just patch out till clean, with some ballistol towards the end of the process. This...
Liked On: 13-03-2014, 07:05 PM
Don't talk about Maca and Rushy like that
Liked On: 11-03-2014, 08:47 PM