rduce the diameter of the expander ball...2 minute job with cordless drill and fine sand paper.
Liked On: 10-12-2023, 09:03 PM
Set up correctly to bump the shoulder 2 thou or so :)
Liked On: 10-12-2023, 09:02 PM
Throw your neck die away and use a full length sizer, then live happily ever after :cool:
Liked On: 10-12-2023, 09:02 PM
https://uploads.tapatalk-cdn.com/20231201/5afcbe13ccc022caf3c7fe0773bab95e.jpg Sent from my iPhone using Tapatalk
Liked On: 05-12-2023, 01:54 PM
must be time to start fuking around with the scopes then :thumbsup:
Liked On: 27-11-2023, 08:39 AM
In my life I get a ton of grief n arseholes about lot's of things, one of the main = my addiction with farking around with scopes n rifles & never having a gun sighted in. Well screw the anti's,...
Liked On: 27-11-2023, 08:39 AM
And there still lies the problem.
Liked On: 27-11-2023, 08:37 AM
Hi Founding around the best way I've found with out wasting valuable components is a ladder test load 1 round of each jumping up in .2 or .3 of a grain start about middle of listed data which...
Liked On: 26-11-2023, 09:44 PM
Greetings, It really depends on the cartridge and what prior experience I have had with it and the powder involved. Some not so common cartridges don't have much data and there is not much data so I...
Liked On: 26-11-2023, 09:44 PM
Consider 145 ELDX with Superperformance powder. There is a thread on here of loads with a few different rifles with some outstanding results of both speed and accuracy.
Liked On: 26-11-2023, 09:43 PM
It's even better than that. "Immediately begin to repeal and replace Part 6 of the Arms Act 1983 relating to clubs and ranges, rewrite the Arms Act 1983 to provide greater protection of public...
Liked On: 24-11-2023, 03:03 PM
Greetings, The actual projectiles you want to use, rather than just the weight, have a big influence on maximum charges so it is best to find data for those. The solid copper types and some of the...
Liked On: 24-11-2023, 09:35 AM
Pretty much hit the nail on the head with that one lol
Liked On: 22-11-2023, 10:26 AM
Get the Dremel out and go 50cal
Liked On: 20-11-2023, 03:47 PM
I neglected to mention that with the extractor back to front (something I have never seen before which proves idiots are a developing species), if the case had not inevitably ruptured through lack of...
Liked On: 13-11-2023, 02:30 PM