Stripped it this afternoon and found the suppressor alignment was spot on, but the suppressor was full of lots of fine copper fragments. I pulled a cartridge and the projectile is made of powdered...
Liked On: 11-09-2018, 09:55 PM
All finished and up to the range to sight in. The 147 grain loads I had scrounged from somewhere were supersonic so no good for evaluating the suppressor, and only mediocre accuracy. I will pull it...
Liked On: 11-09-2018, 09:55 PM
I have just got all the aluminium parts back from the anodisers. I will blue the steel parts and have it fully assembled next week. I will nip up to the range and zero it at 50 metres (should be...
Liked On: 11-09-2018, 09:54 PM
Most of the external parts made, barrel fitted but not yet chambered. Now all the little parts that you can't see need to be made (trigger mechanism, mag catch, suppressor internals, Picatinny...
Liked On: 11-09-2018, 09:52 PM
Yes, based on 20 years research which included a trip to the Pattern Room collection to examine, photograph and measure originals. My drawings are accurate and I also have some original drawings. I...
Liked On: 11-09-2018, 09:51 PM
I loaded a selection of loads and went back to the range this afternoon. As I was mainly checking velocities I was not worried about accuracy but I wound up with 30 shots in a large ragged hole at...
Liked On: 10-09-2018, 08:03 PM
I loaded a selection of loads and went back to the range this afternoon. As I was mainly checking velocities I was not worried about accuracy but I wound up with 30 shots in a large ragged hole at...
Liked On: 10-09-2018, 02:20 PM
I loaded a selection of loads and went back to the range this afternoon. As I was mainly checking velocities I was not worried about accuracy but I wound up with 30 shots in a large ragged hole at...
Liked On: 10-09-2018, 07:49 AM
I loaded a selection of loads and went back to the range this afternoon. As I was mainly checking velocities I was not worried about accuracy but I wound up with 30 shots in a large ragged hole at...
Liked On: 09-09-2018, 09:04 PM
I loaded a selection of loads and went back to the range this afternoon. As I was mainly checking velocities I was not worried about accuracy but I wound up with 30 shots in a large ragged hole at...
Liked On: 09-09-2018, 08:06 PM
I loaded a selection of loads and went back to the range this afternoon. As I was mainly checking velocities I was not worried about accuracy but I wound up with 30 shots in a large ragged hole at...
Liked On: 09-09-2018, 08:00 PM
Just like these ones I am making? 94598
Liked On: 09-09-2018, 05:18 PM
Just like these ones I am making? 94598
Liked On: 09-09-2018, 02:46 PM
Stripped it this afternoon and found the suppressor alignment was spot on, but the suppressor was full of lots of fine copper fragments. I pulled a cartridge and the projectile is made of powdered...
Liked On: 08-09-2018, 10:14 PM
All finished and up to the range to sight in. The 147 grain loads I had scrounged from somewhere were supersonic so no good for evaluating the suppressor, and only mediocre accuracy. I will pull it...
Liked On: 08-09-2018, 08:45 PM