The attached photo is a 50 metre 10 round group, 20mm vertical by 28mm horizontal, 147 grain JHP at 1020 fps. That will do me for short range goats etc. The suppressor is working well with that...
Liked On: 13-09-2018, 05:02 PM
The attached photo is a 50 metre 10 round group, 20mm vertical by 28mm horizontal, 147 grain JHP at 1020 fps. That will do me for short range goats etc. The suppressor is working well with that...
Liked On: 13-09-2018, 04:24 PM
To be honest I am not overly interested in making any for others at this stage (I am too busy enjoying my retirement) but I have started doing some drawings on my own design action just in case I...
Liked On: 12-09-2018, 09:45 PM
I loaded a selection of loads and went back to the range this afternoon. As I was mainly checking velocities I was not worried about accuracy but I wound up with 30 shots in a large ragged hole at...
Liked On: 12-09-2018, 09:45 PM
Stripped it this afternoon and found the suppressor alignment was spot on, but the suppressor was full of lots of fine copper fragments. I pulled a cartridge and the projectile is made of powdered...
Liked On: 12-09-2018, 09:44 PM
I have just got all the aluminium parts back from the anodisers. I will blue the steel parts and have it fully assembled next week. I will nip up to the range and zero it at 50 metres (should be...
Liked On: 12-09-2018, 09:43 PM
To be honest I am not overly interested in making any for others at this stage (I am too busy enjoying my retirement) but I have started doing some drawings on my own design action just in case I...
Liked On: 12-09-2018, 09:28 PM
Yes, based on 20 years research which included a trip to the Pattern Room collection to examine, photograph and measure originals. My drawings are accurate and I also have some original drawings. I...
Liked On: 12-09-2018, 08:44 PM
To be honest I am not overly interested in making any for others at this stage (I am too busy enjoying my retirement) but I have started doing some drawings on my own design action just in case I...
Liked On: 12-09-2018, 07:33 PM
Stripped it this afternoon and found the suppressor alignment was spot on, but the suppressor was full of lots of fine copper fragments. I pulled a cartridge and the projectile is made of powdered...
Liked On: 12-09-2018, 07:32 PM
I have just got all the aluminium parts back from the anodisers. I will blue the steel parts and have it fully assembled next week. I will nip up to the range and zero it at 50 metres (should be...
Liked On: 12-09-2018, 07:31 PM
To be honest I am not overly interested in making any for others at this stage (I am too busy enjoying my retirement) but I have started doing some drawings on my own design action just in case I...
Liked On: 12-09-2018, 04:10 PM
To be honest I am not overly interested in making any for others at this stage (I am too busy enjoying my retirement) but I have started doing some drawings on my own design action just in case I...
Liked On: 11-09-2018, 10:24 PM
I loaded a selection of loads and went back to the range this afternoon. As I was mainly checking velocities I was not worried about accuracy but I wound up with 30 shots in a large ragged hole at...
Liked On: 11-09-2018, 10:24 PM
To be honest I am not overly interested in making any for others at this stage (I am too busy enjoying my retirement) but I have started doing some drawings on my own design action just in case I...
Liked On: 11-09-2018, 09:56 PM