GuyDowding
Member

24 Likes

Page 2 of 2 First 12

• Jump to page:

1. 
   GuyDowding liked post by dannyb On thread : Biggest influences on getting low velocity SD

   annealing brass, charge weight accuracy, seating depth accuracy, trimming, sizing accuracy, finding the sweet spot with a charge ladder then minimising as many variables as you can with all the...

   Liked On: 13-03-2022, 06:05 PM

2. 
   GuyDowding liked post by zimmer On thread : Case Neck runout with redding type s bushing die

   I have 3 sets of Redding comp dies. The only set that gives zero runout is my 6.5AI. The sleeves on this were opened out using the chambering reamer. With the others, have tried all sorts - locking...

   Liked On: 10-03-2022, 07:53 PM

3. 
   GuyDowding liked post by johnd On thread : Case Neck runout with redding type s bushing die

   I have gone back to a F/L Forster die and open up with Sinclair mandrel.

   Liked On: 10-03-2022, 07:53 PM

4. 
   GuyDowding liked post by Waimauku On thread : Case Neck runout with redding type s bushing die

   I had considered whether the bushing/die tolerance was responsible,but I don't know that for a fact.The FL die and then running the cases through the expander die from my sinclair neck turner where...

   Liked On: 10-03-2022, 07:53 PM

5. 
   GuyDowding liked post by chainsaw On thread : Case Neck runout with redding type s bushing die

   Is the run out there before sizing?

   Liked On: 07-03-2022, 08:22 PM

6. 
   GuyDowding liked post by outdoorlad On thread : Case Neck runout with redding type s bushing die

   3-6 thou I wouldn’t worry about it if the loads are accurate

   Liked On: 07-03-2022, 08:21 PM

7. 
   GuyDowding liked post by Mick Hunter On thread : Case Neck runout with redding type s bushing die

   Is the bush able to move slightly in the die so it can center on the neck?

   Liked On: 07-03-2022, 08:21 PM

8. 
   GuyDowding liked post by Tech On thread : Case Neck runout with redding type s bushing die

   If there is more than 5 thou difference between your fired case neck outside diameter and the sized case then Redding suggest you use more than one bushing. I had this same issue when sizing for...

   Liked On: 07-03-2022, 08:20 PM

9. 
   GuyDowding liked post by Friwi On thread : Case Neck runout with redding type s bushing die

   Do you neck turn or not? What is the inside neck run out?

   Liked On: 07-03-2022, 08:19 PM

Page 2 of 2 First 12

• Jump to page: