This incredible “bramble” appeared on a Red Band gumboot this morning. I thought it was stuck on the boot and damn nearly grabbed it to pull it off. Check out the astonishing replication of a bramble...
Liked On: 26-02-2021, 08:26 AM
private land....other than critters for freezer the only thing I would be shooting was the breeze...... you leave broken bits of shot up crap around and you possibly wont be invited back...and it...
Liked On: 22-02-2021, 06:13 AM
Responsible Rushy says steel gongs. Irresponsible Rushy say a filled ninety cubic metre dive cylinder would be a hoot.
Liked On: 22-02-2021, 06:10 AM
Well obviously his licence just expired..
Liked On: 20-02-2021, 10:21 PM
Lots of people should not have firearms licences because of just how silly and dangerous they are and not following simple rules. However I do not trust the motivations behind government and police...
Liked On: 20-02-2021, 09:14 AM
That really pisses me off Gibo. Cunts can catty it in full but can’t carry it out empty. Shits the fuck out of me.
Liked On: 19-02-2021, 07:58 PM
As it should be....some fucking idiots out there with FALs.
Liked On: 19-02-2021, 06:52 PM
This would be near perfect its my go to goat rifle
Liked On: 19-02-2021, 09:00 AM
why not the sweet little reloadable .22 Hornet?
Liked On: 19-02-2021, 08:56 AM
I have used Winchester Rapid Fire Pistol Shorts and they are very quite, and do 800 fps. Problem is they are solids but you could drill them to make them more effective. I use Winchester 40 gr subs...
Liked On: 18-02-2021, 06:55 PM
My take on this is .22lr dam good bunny buster, cheap amo. My jump up from it would be 22 hornet / 22-250 or the ones in-between, you can reload them, not so with .22mag and it gets expensive per...
Liked On: 15-02-2021, 05:19 PM
grandpamac years ago I was loading my 22-250 using my Lyman 310 tool. I decided I would in future neck size in a press so ordered from a company in the SE of the NI a "neck sizing die for 22-250...
Liked On: 15-02-2021, 05:15 PM
Greeting Micky and All, The die makers are between a rock and a hard place when it comes to die dimensions. There is considerable variation in chambers and case wall and neck thickness. Dies need to...
Liked On: 15-02-2021, 05:14 PM
1. Yes, lubrication is necessary for the expander ball. If you don't wash cases afterwards, make sure it's a lubricant that won't interfere with primers. 2. My expander ball travels easier since I...
Liked On: 15-02-2021, 05:07 PM
Good chance it is reducing the neck too much and then the expander is having to work hard to get back through. Hornady FL dies are terrible for this. Measure the necks and use a bushing die with the...
Liked On: 15-02-2021, 05:06 PM