Hunterdave
Member

35 Likes

Page 1 of 3 123 Last

• Jump to page:

1. 
   Hunterdave liked post by gimp On thread : Testing a conventional approach to load development

   To be clear the "changes" visible in 3 shot groups are within the variation that happens within 3 shot groups of a single load. At present there is no evidence at all of any difference between the...

   Liked On: 04-04-2025, 10:04 AM

2. 
   Hunterdave liked post by 7mmsaum On thread : Loading 162 ELDX vs ELDM ?

   Eld-m is always my first choice

   Liked On: 01-04-2025, 06:45 PM

3. 
   Hunterdave liked post by Trout On thread : UPGRADE SUPPRESSER

   Just slightly upgraded my oldish Gunworks Sparton suppresser from 4" forward of barrel to 5"forward.Hopefully quieten the 308 down a little.41mm dia x 9" long to 41mm dia x 13.5"long. Velocity...

   Liked On: 22-03-2025, 07:51 PM

4. 
   Hunterdave liked post by bigbear On thread : Which 4x4

   This is my opinion. If you are buying a late model ute and paying $45 plus buy new and get a extended warranty. And if you can once warranty is up move it on. Also after driving a new auto for 12...

   Liked On: 05-09-2023, 06:22 PM

5. 
   Hunterdave liked post by blip On thread : Which 4x4

   Unless you have a really big wallet stay away from the european umm stuff

   Liked On: 05-09-2023, 06:20 PM

6. 
   Hunterdave liked post by matto1234 On thread : Which 4x4

   We have a dozen hilux from 2010 through to 2022. Nothing more than servicing,diff seals and brake rotors.

   Liked On: 01-09-2023, 10:58 PM

7. 
   Hunterdave liked post by Vandy On thread : Which 4x4

   Spent 3 months overseas driving a newer 2.0 bi-turbo Ranger and I'd never but one. Gutless prick of an engine. If you do go for a Ranger I'd say get the 3.2. My 2 cents

   Liked On: 29-08-2023, 06:25 PM

8. 
   Hunterdave liked post by Flyblown On thread : Which 4x4

   I’m 100% sure I’ve told you guys this before, but I’m going to tell you again. The Gen 7 Hilux (KUN26R) was for years the standard fleet vehicle on the big iron ore mines up north, as it was on...

   Liked On: 29-08-2023, 06:22 PM

9. 
   Hunterdave liked post by tac a1 On thread : Which 4x4

   Were 100% Toyota family. Ive had couple of hi luxes and a Landcruiser. The best hi lux I think was 3.0 L turbo (1kzte engine). A 2002 Model. That was faultless that ute. Towed my boat all...

   Liked On: 29-08-2023, 06:18 PM

10. 
    Hunterdave liked post by Beetroot On thread : Shoulder Bump Advice

    Go off the size that won't chamber as that is what is important. If its new brass it may take a few firings until you are actually doing much sizing.

    Liked On: 09-04-2023, 09:35 PM

11. 
    Hunterdave liked post by dannyb On thread : The importance of Seating depths

    That's why when I do a seating depth ladder I go in 3 thou increments, if you go 10 thou you coupd skip right over a node. Then again you can get luck too, I did a charge ladder last week seated at...

    Liked On: 28-01-2023, 11:26 PM

12. 
    Hunterdave liked post by dannyb On thread : Is this really the state of component shortages?

    Buying to sell on at inflated prices: just a cunt :thumbsup:

    Liked On: 20-07-2022, 07:16 PM

13. 
    Hunterdave liked post by GWH On thread : 284win with rl26

    Here's the velocities from my initial ladder. Barrel is 22"https://uploads.tapatalk-cdn.com/20220707/7463425ecff3d45b152c1ef5220bafeb.jpg Sent from my CPH2197 using Tapatalk

    Liked On: 07-07-2022, 11:40 PM

14. 
    Hunterdave liked post by Makros On thread : Trusted 18650 suppliers?

    Jacob at https://www.piercingthedarkness.co.nz/ one of the forum sponsors. Good guy and good gear.

    Liked On: 04-07-2022, 06:18 PM

15. 
    Hunterdave liked post by Magnetite On thread : Advice please

    Updated rough numbers from GRT: Maximum pressure: 63,817psi Your Load: : ~61,860psi 162gr ELD-M, 3.113", 2820fps, 22", 21°C

    Liked On: 02-04-2022, 09:23 PM

Page 1 of 3 123 Last

• Jump to page: