Jhon
Member

938 Likes

Page 27 of 63 First ... 1314151617181920212223242526272829303132333435363738394041 ... Last

• Jump to page:

1. 
   Jhon liked post by omark On thread : 45 Colt and Lee FCD

   I agree that you get what you pay for. I must say however that Lee come out with a few gems. Their collet dies (older models) I could not be without and the most accurate powder thrower for ball...

   Liked On: 24-12-2022, 05:38 PM

2. 
   Jhon liked post by grandpamac On thread : Handloading for Placid and Challenging Cartridges

   Greetings Jhon, I have found that the data for the 6.5x55 varies widely and is mostly low pressure. Data for AR2209 (H4350) is mostly for the older and slower version from pre 2000. I calculated the...

   Liked On: 22-12-2022, 09:20 PM

3. 
   Jhon liked post by Micky Duck On thread : 45 Colt and Lee FCD

   never seen the need for excessive crimp myself..... go with std die you already have ,IF you end up with projectile moving back into case...then and only then fork out extra $$$ for something...

   Liked On: 22-12-2022, 04:21 PM

4. 
   Jhon liked post by rossi.45 On thread : 45 Colt and Lee FCD

   i use the standard LEE die set for .45LC without issues, have another set in .45/70 . . . not my first choice of make because they are obviously made at a price point but never had a problem or...

   Liked On: 22-12-2022, 04:20 PM

5. 
   Jhon liked post by JohnDuxbury On thread : Red colour inside 44-40 case??

   I wash .44-40 brass in water, and its fine. Just looks old and coppery. I wouldnt worry about that brass it all. Looks like someone fired some kind of duplex load in them. Just go and shoot them....

   Liked On: 12-12-2022, 08:48 PM

6. 
   Jhon liked post by Kelton On thread : Red colour inside 44-40 case??

   I would say they have seen vinegar after having oxidation on them I cleaned up some .308 brass to make an even 50 over the weekend that ended up the same after scrubbing the green off soap vinegar...

   Liked On: 12-12-2022, 11:29 AM

7. 
   Jhon liked post by Marty Henry On thread : Red colour inside 44-40 case??

   It looks quite minor you should see some of my 45/70s that have been left uncleaned for a while with BP residue a simple wash in vinegar and rinse and they are as good as. In in a low power/pressure...

   Liked On: 12-12-2022, 11:29 AM

8. 
   Jhon liked post by Makros On thread : Red colour inside 44-40 case??

   All my black powder cases after a quick wash on Saturday are a brilliant silver/pewter colour. Assume the acid in the BP residue has tarnished them. Another clean with stainless steel media will...

   Liked On: 12-12-2022, 11:28 AM

9. 
   Jhon liked post by shooternz On thread : Red colour inside 44-40 case??

   Those CAS dudes have some strange ideas, I would not be surprised by anything they get up tu.

   Liked On: 09-12-2022, 07:57 PM

10. 
    Jhon liked post by norsk On thread : Dream rifle scope

    This is my Shit&Bender Elite series biodegradeable European scope of the future. Saved long and hard for this. Don't give up on your dreams.

    Liked On: 06-12-2022, 06:50 PM

11. 
    Jhon liked post by Micky Duck On thread : Rifle choice: $1600 budget

    the highest grade leupold he can buy no more than 3x at bottom and probably little point in above 12x at top end..... personally I would be happy with a freedom 3x9x40 or 50 actually I AM happy...

    Liked On: 06-12-2022, 06:48 PM

12. 
    Jhon liked post by Druid On thread : Venison shoulder roast

    Too many hunters leave the shoulders behind , this recipe is just yummy , you can swap out the prunes for dries apricots . Cooking oil can be swapped for dripping , or even better bacon fat , A...

    Liked On: 05-12-2022, 05:21 PM

13. 
    Jhon liked post by dantheman On thread : .307/Tangihuas

    The tangihuas have quickly become my favorite hunting spot, no idea why it gets a bad rap but I'm happy because it means more for me haha. Reason number 1 is I am currently sending this from my...

    Liked On: 03-12-2022, 07:09 PM

14. 
    Jhon liked post by akaroa1 On thread : Cast Lead Thread ?

    I cast 150 22 HORNET 45 grain bullets today and powder coated them Gas checked and sized a couple to measure The .224 sizer is exactly to size and the bullets are now 46.5 grains A very kind...

    Liked On: 02-12-2022, 07:38 PM

15. 
    Jhon liked post by akaroa1 On thread : .22 Magnum Accuracy

    So when I got a very desirable Winchester 1885 low wall takedown in .25 rimfire with the obligatory roached barrel I bored and lined with a suitable barrel and chambered it 22 WMR Sounds easy but...

    Liked On: 02-12-2022, 01:58 PM

Page 27 of 63 First ... 1314151617181920212223242526272829303132333435363738394041 ... Last

• Jump to page: