Joe_90
Also known as Fingers

1566 Likes

Page 58 of 105 First ... 84445464748495051525354555657585960616263646566676869707172 ... Last

• Jump to page:

1. 
   Joe_90 liked post by rossi.45 On thread : Cast bullet Varminting / Medium game Project

   cast some of these today . . 197s i expect to be borderline in 1-12 but they may work at 1600fps, worth a try next time your coming thru Joe_90 grab some of these . . i will be interested to...

   Liked On: 13-12-2021, 05:21 PM

2. 
   Joe_90 liked post by Finnwolf On thread : Solving a Sako design fault

   I flicked a couple of photos of my Sako .22 bolt to gundoc, much relief on my part when he assured me the bolt was not of the ‘fragile’ design, big thanks gundoc:thumbsup:

   Liked On: 12-12-2021, 07:48 PM

3. 
   Joe_90 liked post by Micky Duck On thread : .308 Projectile change?

   yes I did...we used bog std 150grn hornady in BLR with both 2206 or 748...couple grains below max so werent eggzachary honking along...wallabies dies quick smart,red deer did too,and 12" bull thar my...

   Liked On: 11-12-2021, 10:34 PM

4. 
   Joe_90 liked post by planenutz On thread : Chamois general catchment advice

   First you find a catchment full of steep shitty gullies in a mountain range to your west (mainly because there are sweet bugger all mountain ranges to your east that are above water) then within that...

   Liked On: 11-12-2021, 10:27 PM

5. 
   Joe_90 liked post by gundoc On thread : Solving a Sako design fault

   The Sako .22 P94S has a design fault in the bolt locking ring which can cause the bolt handle and locking lug to break off the bolt during opening. This problem is caused by a combination of a steep...

   Liked On: 11-12-2021, 08:34 PM

6. 
   Joe_90 liked post by rossi.45 On thread : What little pesties did you bowl over today?

   185481 1st shot for today's walk, 165yrds. Sako .222 with 6X Khales 50grn. VMax

   Liked On: 08-12-2021, 11:10 PM

7. 
   Joe_90 liked post by rossi.45 On thread : Cast bullet Varminting / Medium game Project

   these 2 molds might be up next from left . . 160grn. Lyman & 180grn. RCBS 185472 Joe_90 the 180grn. would be worth a crack in the 300Blk if the case and chamber allow in your rifle

   Liked On: 08-12-2021, 12:53 PM

8. 
   Joe_90 liked post by Boaraxa On thread : AnyCentral Otago bow hunter?

   The problem with shooting at longer rangers with a bow is called jumping the string , whilst you maybe able to hit targets out past 40-50 yards it’s the sound of the bow , the arrow speed & the deers...

   Liked On: 08-12-2021, 09:05 AM

9. 
   Joe_90 liked post by rossi.45 On thread : Cast bullet Varminting / Medium game Project

   185421 this is where i'm at now . . bullet sized, lubed, gas check, seated with a light crimp over 7.0 grains of Nobels No.2 powder, expecting just over 1,000fps next few days i will do a...

   Liked On: 07-12-2021, 04:14 PM

10. 
    Joe_90 liked post by 40mm On thread : Rituals - what are yours?

    Could probably incorporate all of the above into one dam fine goat 'blessing' ceremony

    Liked On: 03-12-2021, 04:58 AM

11. 
    Joe_90 liked post by MFP On thread : Rituals - what are yours?

    Hmhm, ticklists. I remember sitting in the car listening to two mates. One ribbing the other for forgetting his bolt. And when we hopped out the other realised he forgot one boot. That day I wondered...

    Liked On: 02-12-2021, 10:23 PM

12. 
    Joe_90 liked post by MB On thread : Rituals - what are yours?

    Everything has to be ready the night before with checklists ticked. I'm a fun guy.

    Liked On: 02-12-2021, 10:22 PM

13. 
    Joe_90 liked post by Micky Duck On thread : Cases shorter than max trim length (pistol cal) - Does it matter?

    yeah nah,be all good...some folks have made bottle neck rounds with necks too short (before someone told me to use base bit of lee trimmer) did not make slight bit of difference to going bang and...

    Liked On: 01-12-2021, 08:11 PM

14. 
    Joe_90 liked post by 40mm On thread : Shaved cordite

    And when I first read the title of this thread, I thought Cordite was going to get a Brazilian...

    Liked On: 01-12-2021, 10:20 AM

15. 
    Joe_90 liked post by viper On thread : Show me your knives

    So trying to clear my Christmas orders, 4 to get out. Here's the first. Viper model in 1084, stabilized Rimu, Yellow Russian Burlap micarta and Green canvas Micarta. G10 pins and liners. 184552

    Liked On: 28-11-2021, 06:23 PM

Page 58 of 105 First ... 84445464748495051525354555657585960616263646566676869707172 ... Last

• Jump to page: